Low profile wall brackets (pair of)

£20.50£33.00

Neat wall brackets for use when limited stand off is required.
Available in two different levels of anti corrosion finish and with plain or Nyloc nuts.
Can also be supplied singly, please phone for this.

Carriage charges.
Non UK orders ALWAYS incur a carriage surcharge, please contact us for a quote BEFORE ordering !

Clear selection
SKU: N/A Category:

Description

Low profile wall brackets designed for use when maximum neatness and/or minimal stand off is required though more clearance can be achieved with a cranked pole. Generally used in pairs (unless it’s a small aerial on a short pole), see how far apart should a pair of brackets be ?
Will accept poles between 1.25” and 2” in diameter.

Comes with the sledge(s) and bolts so no separate V bolts are required.

Because the stand off is so small the brackets are actually very strong despite only being 1.5mm pressed steel. 

Available in 2 finishes with, it must be said, hugely different degrees of corrosion protection (in fact, generally speaking, the people who buy the pregalv/plated variety tend to be doing the job for someone else ! ) :
1Pre galv pressings and plated bolts.
2Hot dip galv pressings (finish may vary) and stainless (A2) bolts.

See Pre Galv v Hot Dip Galv and tests on Zinc plating v stainless corrosion resistance.
Pre galvanised and zinc plated, the less effective anti corrosion finishes 420W L5    Hot dip galvanising v pre galvanised corrosion tests 350W L10

Low Profile Bracket (pressing) dimensions 500W L5.jpg

Requires 4 wall anchors (hole slots are 9mm x 14mm) :
Screws (50 & 75mm) with standard plugs / screws (50mm) with universal plugs / sleeve anchors

These clamps are also available singly (please phone for these) :

This product can also be used to mount poles on 4×4 poles, using a M8x60mm nut bolt and washer pack :

The low profile brackets (as well as the nut and bolt kit ! ) available with plain or Nyloc nuts :

 

Carriage charges.