Pole coupler (1.5 inch = 38.2mm) – fits Starlink

£18.50£22.50

Heavy duty product for coupling 1.5” poles together.

Available with Zinc plated or stainless nuts & bolts, and with plain or Nyloc nuts.
Fits the Starlink mounting pole.

 

> > Non UK orders ALWAYS incur a carriage surcharge. < < <

For this item (for ONE coupler) the surcharge for orders to the USA or Canada (payable with this button) is :
5 day plus service = from £22.00 surcharge
1 to 3 day service = from £35.00 surcharge

For other countries please contact us for a quote BEFORE ordering !
Carriage charges.

Clear selection
SKU: N/A Categories: ,

Description

Pole Coupler for 1.5” (38.2mm) Masts

Non UK orders ALWAYS incur a carriage surcharge.

This is a heavy duty product for coupling 1.5” poles together.
Zinc plated (but good quality zinc plated) 2.5mm thick steel pressings at 1.5″ (38.2mm) internal diameter (but will clamp down to 35.5mm).
The coupler is 11.5″ long (29cm) so approximately 14.5cm of a pole (or a Starlink MKII) will fit down to the “middle indents”. It is sufficiently strong that the pole would fail before the coupler.

Available with plain or Nyloc nuts, and with Zinc plated or stainless (A2) nuts & bolts.

Fits the Starlink mounting pole : our 1.5″ pole coupler will actually clamp down to the 35.8mm diameter of the (thinner) lower section of the Starlink Mk I pole and even just using that end 60mm of the pole will still be far stronger than Starlink’s pole adapter. However, if it was me, I’d be going further up the pole (to maximise the strength and stability of the install), up to just below the point where the cable exits and then packing out the lower narrow end to match the diameter of the wider top section (see picture).
The diagram below shows the coupler is actually even more suitable for the “new” smaller rectangular Starlink Mk II dish because the cable can be routed down the inside of the pole so even more of the pole can be inserted into the coupler = even more stable install ! In fact, arguably, with a MkII Starlink the tape packing is not really necessary (if the cable is routed down the inside).

The coupler can also be modified to fit the High Performance Starlink :

 

Size of Starlink carrier package : 30cm x 11cm x 5cm at 1.4Kg